EMT Practice Test

1. Question Content...


Question List

Question1: What two advantages does FortiNAC provide in the OT network? (Choose two.)

Question2: Refer to the exhibit, which shows a non-protected OT environment.

An administrator needs to implement proper protection on the OT network.
Which three steps should an administrator take to protect the OT network? (Choose three.)

Question3: Refer to the exhibit.

Based on the topology designed by the OT architect, which two statements about implementing OT security are true? (Choose two.)

Question4: You are investigating a series of incidents that occurred in the OT network over past 24 hours in FortiSIEM.
Which three FortiSIEM options can you use to investigate these incidents? (Choose three.)

Question5: An OT network architect needs to secure control area zones with a single network access policy to provision devices to any number of different networks.
On which device can this be accomplished?

Question6: When you create a user or host profile, which three criteria can you use? (Choose three.)

Question7: Refer to the exhibit.

Given the configurations on the FortiGate, which statement is true?

Question8: An OT network architect needs to secure control area zones with a single network access policy to provision devices to any number of different networks.
On which device can this be accomplished?

Question9: Which three Fortinet products can be used for device identification in an OT industrial control system (ICS)? (Choose three.)

Question10: Refer to the exhibit.

You are navigating through FortiSIEM in an OT network.
How do you view information presented in the exhibit and what does the FortiGate device security status tell you?

Question11: Refer to the exhibit and analyze the output.

Which statement about the output is true?

Question12: Refer to the exhibit.

You are navigating through FortiSIEM in an OT network.
How do you view information presented in the exhibit and what does the FortiGate device security status tell you?

Question13: Refer to the exhibit.

Based on the Purdue model, which three measures can be implemented in the control area zone using the Fortinet Security Fabric? (Choose three.)

Question14: An OT architect has deployed a Layer 2 switch in the OT network at Level 1 the Purdue model-process control. The purpose of the Layer 2 switch is to segment traffic between PLC1 and PLC2 with two VLANs. All the traffic between PLC1 and PLC2 must first flow through the Layer 2 switch and then through the FortiGate device in the Level 2 supervisory control network.
What statement about the traffic between PLC1 and PLC2 is true?

Question15: Refer to the exhibit.

An OT administrator ran a report to identify device inventory in an OT network.
Based on the report results, which report was run?

Question16: Refer to the exhibit and analyze the output.

Which statement about the output is true?

Question17: What can be assigned using network access control policies?

Question18: An OT supervisor has configured LDAP and FSSO for the authentication. The goal is that all the users be authenticated against passive authentication first and, if passive authentication is not successful, then users should be challenged with active authentication.
What should the OT supervisor do to achieve this on FortiGate?

Question19: Refer to the exhibit.

An OT architect has implemented a Modbus TCP with a simulation server Conpot to identify and control the Modus traffic in the OT network. The FortiGate-Edge device is configured with a software switch interface ssw-01.
Based on the topology shown in the exhibit, which two statements about the successful simulation of traffic between client and server are true? (Choose two.)

Question20: An OT administrator is defining an incident notification policy using FortiSIEM and would like to configure the system with a notification policy. If an incident occurs, the administrator would like to be able to intervene and block an IP address or disable a user in Active Directory from FortiSIEM.
Which step must the administrator take to achieve this task?